Would you like to stamp or stencil onto thinner materials such as copy paper or vellum? If so, our Low-Tack Sticky Mat will do the trick! It features an etched grid for easy alignment in your Stampwheel and is a little less tacky than our original Sticky Mat.
Instructions:
Remove the photopolymer sticky mat from the acetate sheet.
Place it inside the Stampwheel with the engraved side down, flat side up.
Clean any ink residue immediately with a wet wipe to avoid staining. Please keep in mind that some dark colors (especially reds and blues) may stain the photopolymer. This will not affect its performance. You can protect the photopolymer mat by placing a scrap piece of paper to catch the ink when stamping off the edge of your project.
To keep your mat clean and sticky, occasionally remove from the Stampwheel and wash it under running water. Make sure you rub the dust off while rinsing.
After washing, allow it to air dry
Features:
7.5" x 7.5"
Clear Photopolymer
Cleans Easily
Multi-purpose
Made in USA
Altenew Stampwheel - Low Tack Sticky Mat: Grid
Shop location
Pickup available,
Usually ready in 24 hours
294 Russell Terrace Chapel Hill QLD 4069 Australia
Would you like to stamp or stencil onto thinner materials such as copy paper or vellum? If so, our Low-Tack Sticky Mat will do the trick! It features an etched grid for easy alignment in your Stampwheel and is a little less tacky than our original Sticky Mat.
Instructions:
Remove the photopolymer sticky mat from the acetate sheet.
Place it inside the Stampwheel with the engraved side down, flat side up.
Clean any ink residue immediately with a wet wipe to avoid staining. Please keep in mind that some dark colors (especially reds and blues) may stain the photopolymer. This will not affect its performance. You can protect the photopolymer mat by placing a scrap piece of paper to catch the ink when stamping off the edge of your project.
To keep your mat clean and sticky, occasionally remove from the Stampwheel and wash it under running water. Make sure you rub the dust off while rinsing.
After washing, allow it to air dry
Features:
7.5" x 7.5"
Clear Photopolymer
Cleans Easily
Multi-purpose
Made in USA
Fantastic little light set that’s simple & easy to put on a card. I made a new baby card for the birth of my grandson and managed to put the button between layers of a lion easily. I hot glued the lights where I wanted them. It was that easy, I would buy again.
Really easy to use, I used my platinum 6 to cut these out at it is a workhorse for felt.
Only needed to send through the machine one to cut. Make sure that you use the wool felt, acrylic takes forever to cut through and the result is not as nice.